I will start this update by embedding all of the videos I’ve collected to this post. Please note I am unable to upload videos directly to this site, and Youtube is refusing to allow Hobby #0 to the page.
Now on to the update!
Over the past 3 months, I’ve tested 3 times, an initial run fresh from the package labeled 0, and 2 runs since then of the individual storage methods. So far I’ve seen no difference in the final products, however I have found the prints are more likely to fail in the initial lay-down layers at the start to to differences in the environment the printer is in. Despite attempting to maintain a stable climate, as the winter months come, the overall environment within the house shifts, leading to variations in the print that are hard to counteract without invalidating the experiment. I’ve included the singular failure that failed farther than 5 minutes into the print, as this could be an example of the print quality becoming affected by the storage environment.