- initial design ideas
- cardboard mock-up
- cutting down MDF sheet to chassis size
- attaching motor mounts and motors to the chassis
- progress at checkpoint 1 (robot designed to start in starting zone, go up right ramp, bump into boarding pass, and then come back down same ramp to start area)
- Made a holder for the QR code by sticking pieces of MDF together, with wood glue.
- Added a CDS Cell, Custom 3D printed light funnel, and red light filter to the bottom of chassis in between the two skids (reads in the boarding pass light)
- Added a servo to the front of the chassis, attached a lever glued with a flat hammer head made out of MDF (flip fuel lever and passport stamp)
- Added a luggage holder made out of three pieces of MDF glued together on the top of the chassis (launches the luggage into the luggage dropoff)
- Final design of the robot