void myCode()
{
//—————————————————————————————-
// myCode();
//
// This is the tab where the programming of your vehicle operation is done.
// Tab _00_AEV_key_words contains a compiled list of functions/subroutines used for vehicle
// operation.
//
// Note:
// (1) After running your AEV do not turn the AEV off, connect the AEV to a computer, or
// push the reset button on the Arduino. There is a 13 second processing period. In
// post processing, data is stored and battery recuperation takes place.
// (2) Time, current, voltage, total marks, position traveled are recorded approximately
// every 60 milliseconds. This may vary depending on the vehicles operational tasks.
// It takes approximately 35-40 milliseconds for each recording. Thus when programming,
// code complexity may not be beneficial.
// (3) Always comment your code. Debugging will be quicker and easier to do and will
// especially aid the instructional team in helping you.
//—————————————————————————————-
// Program between here——————————————————————-
celerate(1,0,15,2.5);
motorSpeed(2,15);
goFor(1);
brake(1);
celerate(2,0,27,4);
motorSpeed(2,27);
goFor(2.7);
celerate(2,27,15,1);
brake(2);
reverse(2);
celerate(4,0,31,2);
motorSpeed(4,35);
goFor(1);
brake(2);
motorSpeed(1,35);
goFor(3);
brake(4);
goFor(1);
reverse(1);
celerate(1,0,19,2);
motorSpeed(2,35);
goFor(2);
motorSpeed(4,19);
goFor(2);
celerate(4,19,0,3);
brake(4);
// And here——————————————————————————–
} // DO NOT REMOVE. end of void myCode()